Pulsar PGD105TiSCO - Preparation; Unpacking the Generator; Adding Engine Oil

8
Preparation
Preparation
Your generator requires some assembly. This unit ships from our
factory without oil; it must be properly lled with oil before operation.
Unpacking
1. Set the shipping carton on a solid, at surface.
2. Remove everything from the carton except the generator.
3. Using the carrying handles of the unit, carefully remove the
generator from the box (two people lifting is recommended).
Add Engine Oil
CAUTION
DO NOT attempt to crank or start the engine before it has been
properly lled with the recommended type and amount of oil.
Damage to the generator because of failing to follow these
instructions will void your warranty.
Failure to follow the instruction may result in the damage to your
generator and other property.
NOTICE
If running the generator in extreme temperatures, refer to the
following chart for recommended oil type.
1. Place the generator on a solid, at, level surface.
2. On the left side of the generator, loosen the screws and remove
the maintenance cover.
3. Remove oil ll cap/dipstick to add oil.
4. Using a funnel, as needed, add the appropriate type of oil until the
oil level is at the proper level. SAE 10w-30 oil is recommended for
general use. DO NOT OVERFILL. Replace oil ll cap/dipstick and
secure maintenance cover.
5. Check engine oil level daily and add as needed.
NOTICE
Once the oil has been added, a visual check should show oil about
1-2 threads from running out of the ll hole. When using the
dipstick to check the oil level, DO NOT screw in the dipstick while
checking.