F1 compile F2 AddRow F3 Del Row F4 NewFile F8 save
1: G21
2: G91
3: _
F1 compile F2 AddRow F3 Del Row F4 NewFile F8 save
1: G21
2: G91
3: _
Figure 38. New code
NEW CODE
In the editing code interface, you can press key [F4] to create an new
file to input your own code, shown as Fig. 38.
COMPILE CODE
After create a new code or edit the code, if you want to know the code
is valid or not, in the edit interface, press [F1] ,you can compile code to
check whether the code is correct.
07
Parameter setting
In the main interface, you can get the parameter interface by pressing key [F3] (Para). The parameter function interface is showed in Fig. 39.
To Next Page