Purelogic HYD-2300

HYD-2100. CNC Plasma&Flame Cutting Control System
Edition of 28.07.2015
37
www.purelogic.ru8 (800) 555 63 74
F1 Input kcehCfleS 6FdrByeK 5FtuptuO 2F
F7
DataTime
F8
SystemDef
input
Forward limit
Back limit
Right limit
Left limit
Emergency stop
Arcing feedback
Position detect
Plasma crash
Up move input
Down move input
Left move input
Right move input
Acceleration input
Deacceleration input
Torch up input
Torch down input
F1 Input kcehCfleS 6FdrByeK 5FtuptuO 2F
F7
DataTime
F8
SystemDef
input
Forward limit
Back limit
Right limit
Left limit
Emergency stop
Arcing feedback
Position detect
Plasma crash
Up move input
Down move input
Left move input
Right move input
Acceleration input
Deacceleration input
Torch up input
Torch down input
Figure 46. System Parameters Figure 47. Diagnostic interface
Note: when any parameter has been modified, you must take preservation operation to keep modification valid, or the system will take the original
parameters.
08
Diagnosis function
You can be diagnosing the I/O and keyboard in the interface (Fig. 47).