Purelogic HYD-2300

HYD-2100. CNC Plasma&Flame Cutting Control System
Edition of 28.07.2015
43
www.purelogic.ru8 (800) 555 63 74
F8 OK
Rectangle
lavOelgnairTelcriC L-Bracket Trapezoid Slant Rec
CirSector
GambrelRec RoofedRec CircleFla
ConcaveT
FLange Elbow
ConcaveP.
Convex
RecinRec
ConcaveR.
ConcaveT
BevelRec
Cross L Corner U Shape Groove1 Groove2
Horizont
Vertical HoleCir.
RecWin. Hole-in-Rec.
HolesCir. HolesFla. 4HoleRec. 4HolesRec.
5HolesRec.
CurvedTr. CurveP. Testing GridShape
ceRnielcriC.RevacnoC.RrenroCnogatcO
ConvexR.
5HolesRec.
F8 OK
Rectangle
lavOelgnairTelcriC L-Bracket Trapezoid Slant Rec
CirSector
GambrelRec RoofedRec CircleFla
ConcaveT
FLange Elbow
ConcaveP.
Convex
RecinRec
ConcaveR.
ConcaveT
BevelRec
Cross L Corner U Shape Groove1 Groove2
Horizont
Vertical HoleCir.
RecWin. Hole-in-Rec.
HolesCir. HolesFla. 4HoleRec. 4HolesRec.
5HolesRec.
CurvedTr. CurveP. Testing GridShape
ceRnielcriC.RevacnoC.RrenroCnogatcO
ConvexR.
5HolesRec.
Figure 55. First page of graph Figure 56. Chip size interface
You can press [↑], [↓], [←], [→] to modify sizes, after modification, press [F8] to confirmed. Press any key to return to graphics processing interface.
FILM/HOLE SIZE
In Fig. 56 interface, you can press [F2] to choose hole size, shown as Fig. 57.
Modify sizes like modify chip sizes.
After modification, press [F8] to confirmed. Press any key to return to graphics processing interface.
Note:
The following graphics don’t have hole sizes:
Straight line groove, Bevel groove, Straight line kerf, Vertical kerf, Hole-in- Rotundity, Rectangle window, Hole-in-Rectangle, Four-holes in Rotundity,
Holes in flange, Four-holes in rec, Four-holes in Filleted corner rec, Five-holes in rec, Five-holes in Filleted corner rec, Curved trapezoid, Curved
polygon, Testing Shape, Grid Shape.