12
The use of BIOS
Figure 64. Power on Figure 65. BIOS interface
When the system powers on, it will display as shown in Fig. 64. When press DEL before the system counts down to 0, the system will
enter the BIOS. If other keys are pressed, the system will enter in before
counting down to 0.
System upgrade
After entering BIOS, press F1 to upgrade the system, it should satisfy the following conditions:
Flash Disk is connected to the system. There should be the UserApp.exe upgrade file in the root folder of the flash disk. Pressed F1 to upgrade when the
conditions are satisfied, when completing the upgrading, press F6 to reboot.
Welcome interface upgrading
After entering BIOS, press F2 to upgrade the welcome interface completely, it should satisfy the following conditions:
• Flash Disk is connected to the system.
• There should be the STARTBMP.BIN upgrade file in the root folder of the flash disk.
Pressed F6 to upgrade when the conditions are satisfied, when completing the upgrading, press F6 to reboot.
F1 - System software update
F2 - Welcome picture update
F3 - Motion update
F4 - System backup
F5 - System recovery
F6 - Start system
To Next Page
Loading...