PURONICS iGen - User Displays and Settings (continued); Manual Regeneration; Set Time of Day

iGen
®
Man u al Page 17
Manual Regeneration
Sometimes there is a need to regenerate the system sooner than when the system calls
for it, usually referred to as manual re gen er a tion. There may be a period of heavy
water usage because of guests or a heavy laundry day.
To initiate a manual regeneration at the preset delayed regeneration time, when the
regeneration time option is set to “NORMAL” or “NORMAL + on 0”, press and
release REGEN. The words “REGEN TO DAY” will  ash on the display to indicate
that the system will re gen er ate at the preset delayed re gen er a tion time. If you pressed
REGEN in error, pressing the button again will cancel the request. Note: If the
regeneration time option is set to “on 0” there is no set delayed regeneration time so
“REGEN TODAY” will not activate if REGEN is pressed.
To initiate a manual regeneration immediately, press and hold REGEN for three
seconds. The system will begin to regenerate immediately. The request cannot be
cancelled.
Note: For softeners, if brine tank does not contain salt,  ll with salt and wait at least
two hours before regenerating.
REGEN TODAY will be
displayed if a regeneration is
expected “Tonight.”
STEP 3U - Current Time (minutes): Set the minutes of the day using ▼ or ▲. Press
NEXT to exit Set Clock. Press REGEN to return to previous step.
STEP 1U – Press SET CLOCK.
STEP 1U
STEP 2U - Current Time (hour): Set the hour of the day using ▲ or ▼. AM/PM
toggles after 12. Press NEXT to go to step 3U.
STEP 2U
STEP 3U
Set Time of Day
The user can also set the time of day. Time of day should only need to be set after power outages lasting more than 8 hours,
if the battery has been depleted and a power outage occurs, or when daylight saving time begins or ends. If a power outage
lasting more than 8 hours occurs, the time of day will  ash on and off which indicates the time of day should be reset. If a
power outage lasts less than 8 hours and the time of day  ashes on and off, the time of day should be reset and the battery
replaced.
RETURN TO
NORMAL MODE
User Displays / Settings (continued)