Installation
-5-
30
1. Choose the mounting location where the unit will not interfere with the normal
driving function of the driver.
2. Before finally installing the unit, connect the wiring temporarily and make sure
all connected up properly and the unit and the system work properly.
3. Use only the parts included with the unit to ensure proper installation. The use
unauthorized parts can cause malfunctions.
4. Consult with your nearest dealer if installation requires the drilling of holes or
modifications of the vehicle.
5. Install the unit where it does not get in the driver s way and cannot injure the
passenger if there is a sudden stop, like an emergency stop.
. If installation angle exceeds 30 from horizontal, the unit might not give its
performance.
NOTES:
it is
of
other
. Avoid installing the unit where it would be subject to high temperature, such
as from direct sunlight, or from hot air, from the heater, or where it would be
subject to dust, dirt or excessive vibration.
7
optimum
'
6
DIN FRONT/REAR-MOUNT
This unit can be properly installed either from "Front"(conventional DIN
Front-mount) or "Rear"(DIN Rear-mount installation, utilizing threaded
screw holes at the sides of the unit chassis). For details, refer to the following
illustrated installation methods.
Revoving the unit
1. Press the button to release the front panel .REL
2. Remove the control panel .
To Next Page
Loading...
Need help?
General
