User Manual
Page: 13
10. Intelligent Setting
If intelligent set is enabled by your engineer, the system automatically recognises whether to full set
(Area A), or part set. (Area B). ‘Flexi Set’ (Page 18) should be disabled for this feature to work
properly.
Enter a valid PIN code, or present a valid
tag to the circled area, or press
on
the keyfob.
The system will set in area B (the user
code/tag/keyfob must be programmed
for areas A and B).
If a final exit input is activated during
the setting procedure the system will
quick set area A.
To Next Page
Loading...
