Pyronix Enforcer V10 User Manual

17
Enforcer V10 User Guide
Intruder Alarm Homescreen
Outputs
Tap the output to
trigger it. Whilst
triggered, the icon will
turn red. Tap to turn
o.
Disconnect from system
Tap this to disconnect
from the system and
return to the homescreen
Inputs in area
Tap this to view all the
inputs allocated in
the above area.
Input status
Displays the status of
the input such as
open, closed, tamper
or bypassed.
Control panel settings
Tap here to view the
system ID, change the
alias, view history/logs
and delete control panel.
Set/unset padlock
Displays whether the
area is set or unset. To
arm the area, tap the
padlock and once set
the icon will change to
a red closed padlock.
Tap again to unset the
area.
Omit input slider
If the input has been
programmed so it can
be omitted, this is
used to operate that
function. Tap to slide
on and o. Whilst the
bar is green, the input
is active
Input information
Tap the cog to view
information about the
input such as which
areas it has been
allocated in, the device
location and its status.
Please note: If there has been alarm event, the red padlock will appear as a red bell instead. To unset,
tap the red bell and it will return to a green padlock.

Pyronix Enforcer V10 Specifications

General

Brand	Pyronix
Model	Enforcer V10
Category	Security System
Language	English