Pyronix Enforcer V10 - Fault Indications & Unable to Set; Control Panel Fault Indications; Unable to Set System; Keyfob Fault Indication

8
Enforcer V!0 User Guide
Using the Wireless Keyfob
To unset via a keyfob. Press .
The keyfob LED will start to ash green indicating that the system
has unset.
Resetting the system after an alarm can only be done at the keypad.
Please note: Unsetting with a keyfob will only be allowed if your engineer
has enabled this.
<2 seconds
Fault Indications & Unable to Set
Fault Indications
Control Panel
Any faults that occur on the system will be easily
recognised by the ashing ALERT LED.
Alarm Panel
Time 10:09 c
To see what the fault is, enter a valid PIN code, or
present a valid tag, or press  on the keyfob.
Depending on how the system has been set up by
your engineer, it may be possible to set the system
with a fault, to do this press f.
Control Panel
Battery Fault
Please note: Any fault may aect the overall performance of your alarm control panel and therefore your
engineer should be contacted for further assistance if any fault is active.
Unable to Set
Control Panel Indication
If ‘unable to set’ is displayed, it indicates that an input
is open and the area where the input is should be
checked for open windows, pets, movement etc.
If the problem cannot be solved contact your
engineer, or omit the input.
Unable To Set
Input 01
Keyfob Indication
If the panel is unable to set for any reason, the keyfob status LED ashes amber indicating a
fault is on the system.