Pyronix Enforcer V10 - Setting the System; Setting System with PIN or Proximity Tag; Setting System with Wireless Keyfob

6
Enforcer V!0 User Guide
Setting the System
Using a PIN Code or Proximity Tag
Enter a valid PIN code or present a valid tag to the
symbol as shown.
Enter Your Code
[******]
Enter the area you wish to set and press f.
‘Please wait setting wireless’ will be displayed.
Set Areas?
[A ]
There are three dierent setting methods your
installer will instruct you through:
Final Door: Leave the building and make sure the
exit door is closed properly.
Timed: Make sure you leave the building before the
timer shown on the keypad expires.
Push to set: Press the push to set button installed by
your engineer to set the system.
Please leave via
Exit Route
Using the Wireless Keyfob
To set via a keyfob. Pressand hold for more than 2 seconds.
The keyfob LED will start to ash green indicating that the system
is starting to set.
‘Please wait setting wireless’ will be displayed on the keypad and
the programmed area will begin to set.
To ‘quick set’, press and hold thekey again for four seconds.
Once set, the keyfob LED will illuminate RED indicating that the
system is now set.
<2 seconds