10
EURO 76 User Guide
Entry Control
The readers may be used for entry control, which means they can operate automatic locks for
example, as well as arming and disarming the system. This can be set up by your engineer.
Unlocked
Locked
Unlocked
Locked
Entry Control Instructions
Arming: Present a valid tag to the reader, the GREEN LED will illuminate on the external reader,
remove the tag, the door will unlock, then present the same tag within 10 seconds and the system
will arm and the door will lock.
Disarming: Present a valid tag to the reader and then remove it, the status will be shown (the
alarm symbol will illuminate indicating the system is armed on the internal reader and the RED
LED on the external reader), present the same tag within 10 seconds again and the system will be
disarmed, and the door will unlock. Once disarmed, the door can be unlocked.
Access Control/Entry Control: The readers can be used also for opening doors only without the
ability to set and unset. Please contact your engineer for more information on this feature.
ANTICODE / ENGINEER RESTORE
Anti-Code Restore
Your engineer may have set up the system so that either an ‘Anti-Code’ or ‘Engineer Restore’
is required in order to fully reset the alarm system. What this means is that there will be certain
conditions (specified by your engineer in the programming) that will require more than just your
user code/tag to restore the system back to its normal state.
After alarm activation has occurred, enter a
valid PIN code, present a valid tag, or press
on the key fob to silence the alarm.
The keypad will display as shown to the right.
It is essential to take note of the number, on the
screen (including the ‘G’) and call your Alarm
Receiving Centre (ARC).
Press h.
Alarm Silenced
Restore G76491
To Next Page
Loading...
Need help?
General
