Pyronix EURO 76 - ENGINEER AND CERTIFICATION INFORMATION; Engineer Information; Certification

29
EURO 76 User Guide
ENGINEER CONTACT DETAILS AND TABLES
ENGINEER INFORMATION
Alarm Company
Date of Installation
Site Reference
Engineer Name
Engineer Contact Number
Installed to Grade
Environmental Class II
Your panel is suitable for use in installations designed to meet the European requirements of
Security Grade 2, Environmental Class II. When all parts are working normally, this equipment in
combination with the PSTN or GSM and suitable ARC equipment will meet the requirements of
ATS2 /LAN or Wi-Fi or GPRS meet the requirements of ATS5.
External readers and sirens meet the requirements of environmental class 4.
Number of Code Differs: Tag hex code.
Your panel is designed to automatically inhibit certain functionality. The factory default settings are
shown below:
Intruder Alarm Signal
After 3* unconfirmed alarms in the same area or 1 confirmed alarm.
*This figure is programmable by the Engineer.
Tamper Alarm Signal
After 3* unconfirmed alarms in the same area or 1 confirmed alarm.
*This figure is programmable by the Engineer.
Keypad
After 30 key presses without entering a valid code, keys are disabled for 90 seconds. After
reinstatement, this will be repeated after each 7 key presses until a valid code is entered.
Tag Reader (or tag at a keypad)
If an invalid tag is presented 6 times without a valid tag presented, the respective keypad or
reader will be disabled for 90 seconds. After reinstatement, this state will be repeated after 2
invalid tags are presented to any reader.
Certification
All wireless devices comply with the following EU requirements:
EMC Directive 2014/30/EU
Low Voltage 2014/35/EU
RE Directive 2014/53/EU
And meet the following standards where relevant: