PCX 256 USER MANUAL
RINS867-2 Page: 15
2.3.2 Disarming Partitions / Arm Modes via the Internal Tag Reader
1. To disarm the system, hold up a valid card/tag until the UNSET LED is illuminates, and remove
the card/tag. The system will be disarmed.
2.4 Arming / Disarming Via The External Tag Reader
Once the relevant cards/tags have been programmed into the system (see page ‘Change Codes’
page 22), you may arm and disarm via the external tag reader.
Please note that ‘Flexi-Arm’ may need to be disabled so that the card will arm the assigned
partitions automatically. This is described on page: 24.
2.4.1 Arming Partitions / Arm Modes via the External Tag Reader
1. To arm the system, hold up a valid card/tag until the left GREEN LED comes on, and remove
the card/tag.
2. Hold up the card/tag again, the system will start to arm the assigned Partition(s) / Arm Mode.
Remove the card/tag.
3. Once the assigned Partition(s) / Arm Mode have been armed, the GREEN LED will extinguish.
NOTE: The system will only arm depending on what ‘Exit Mode’ is programmed. This would
have been selected by your engineer. For example:
Power
Alarm
Tamper
Fault
Unset
Tag
To Next Page
Loading...
Need help?
General
