PCX 256 USER MANUAL
RINS867-2 Page: 31
4. ‘Calling Remote PC’ will then be displayed. If the call fails, then please check your telephone
connections and modem numbers.
5. Press the key to return back to the Manager Menu.
4.13 Allow Engineer Menu
If this function is enabled, the engineer will require authorisation from the user to access the
Engineers menu.
1. Use the ¦ and keys to scroll to ‘ALLOW ENGR MENU’. Press the key.
2. Select the following:
Ø Enter ‘0’ = No – To disallow engineer access (only accessible from the manager mode)
Ø Enter ‘1’ = Yes – To allow engineer access
3. Press the key, you will be returned to the engineer menu.
4.14 Block Remote Arm
Your alarm may be configured so that your alarm installation company or company manager can
arm or disarm the system remotely via the PC. Should you wish to block this access, select ‘Yes’
for this function.
1. Use the ¦ and keys to scroll to ‘BLOCK REMOTE ARM’. Press the key.
2. Select the following:
Ø Enter ‘0’ = No – To block remote arming
Ø Enter ‘1’ = Yes – To allow remote arming
3. Press the key, you will be returned to the engineer menu.
4.15 Block UDL
If this function is enabled, connecting to the PCX system via the PC software (upload/download
software) will be only allowed in the Engineers Mode.
1. Use the ¦ and keys to scroll to ‘BLOCK UDL’. Press the key.
2. Select the following:
Ø Enter ‘0’ = No – To allow upload/download access
Ø Enter ‘1’ = Yes – To block upload/download access
3. Press the key, you will be returned to the engineer menu.
4.16 Enter Anti- Code
This function will tell you if there are any engineer / anti-code features turned on.
You must enter your anti-code / engineer code to fully reset the system.
4.17 Exit Manager Mode
Select this option to save any changes you have made, and return to disarmed mode.
To Next Page
Loading...
Need help?
General
