How to resolve a MODEM FAULT on my Pyronix Security System?
If the modem is not present, ensure that the “Disable Digi” option is set to ‘YES’ and “DOWNLOAD MODE” is set to ‘NONE’ or ‘RS232’. If the modem is present but not detected, check that the Digi Modem cable is connected correctly.
What does BATTERY FAULT mean on my Pyronix PCX 46 Security System?
This indication is normal during recharge after a mains failure.
What to do if 485/COMMS are lost on my Pyronix PCX 46?
This can occur during routine initialisation. However, if it persists, check the display on other keypads to determine if the failure is isolated to a single keypad or a complete system BUS failure. You might also temporarily install an additional keypad to troubleshoot.
What does 'FUSE x FAULT' mean on my Pyronix PCX 46 Security System?
This message indicates that the identified fuse has failed, or the output protected by the fuse is drawing excessive current. Note that Fuse 1 protects PGMs, Fuse 2 protects the BELL, Fuse 3 protects AUX, Fuse 4 protects the BUS, and Fuse 5 protects the BATTERY.
How to fix a BELL TAMPER error on my Pyronix PCX 46 Security System?
Check that Terminal TR should be at or near 0v. If it is not, check if the Bell Tamper switch is closed. Also, verify that Fuse F2 is intact and check the connections to the SAB.
Why is my Pyronix PCX 46 unable to arm?
If the system is unable to arm, it may be due to an input that is open. Correct this issue, or call an engineer for assistance.
What should I do if there is code guessing on my Pyronix PCX 46 Security System?
Press the X key to clear the code guessing attempt.
What does ATE LINE FAULT mean on my Pyronix Security System?
This is only operative if the Site Option "ATE Input" is set to 'UK STU' or 'ATE Line Fault.' Check the voltage on the input pin; if it is +5/12 volts, the connected device is showing a fault. Note that the 'Line Fault' timer is operative.
What does LOW VOLTS mean on my Pyronix Security System?
During a mains failure, the battery volts are below the normal ‘battery fault’ level.
What to do if there is a BELL Fault on Pyronix Security System?
Correct the fault at the warning device to restore the output.
General| Wired zones | 8 |
|---|---|
| Wireless zones | 38 |
| Backup Battery | 7Ah |
| Humidity | 95% non-condensing |
| Operating Temperature | -10°C to +40°C |
To Next Page
