PCX 46 Programming Reference
Page: 41
8.2.7 Errors When Arming
Fault Description Solution
Please leave via
exit door
If the exit mode is programmed
as Final Door, then you must
leave through that door to arm
the system.
Leave via the agreed exit route.
Exit Via… If any follow detectors or door
contacts are open during the
arming procedure, this prompts
you to close them.
Close all inputs.
Unable To Arm A fault condition exists on the
system. Details of the fault will
scroll on the display.
Correct the problem if it is an input which
is open, or call engineer.
Alarm during the
arming
Fail to arm time has been
exceeded.
Leave the premises within the fail to arm
time, increase the fail to arm time in
timers or disable this feature in system
options.
Alarm during the
arming
procedure
Instant inputs have been
activated.
During the arming procedure do not
activate instant inputs.
To Next Page
Loading...
