36
© 2008 Directed Electronics. All rights reserved.
Step Function
2
Delete remotes: This feature erases all remotes from the memory of the security
system. This is useful in cases when a customer’s remote is lost or stolen.
Note: This does not reset the programmed features of the security system or
reset the Virtual Tach setting.
3
Reset Features: This resets features all of the security system to the factory
default settings.
Note: This feature does not delete the remotes from the security system or reset
the Virtual Tach setting.
4
Virtual Tach Reset: Deletes all previously learned values for Virtual Tach, and on
the next remote start sequence the unit begins virtual tach initialization.
Note: The “Zap” feature on the Bitwriter does not reset the Virtual tach
setting.
4. Transmit. While holding the Valet/Program switch,
press the button on the remote control. The unit chirps
to confirm that the code has been successfully pro-
grammed. It is not possible to teach a remote control
button to the system more than once.
5. Release. Once the code is learned, the Valet/Program
switch can be released. You can advance from one
function step to another by releasing the Valet/Program
switch and tapping it to advance function steps and then
holding it.
Learn Routine is exited if:
The door is closeds
The ignition is turned offs
The program switch is pressed too many timess
More than 30 seconds elapses between stepss
To Next Page
Loading...
Need help?
General
