HF-90 Operation & Installation Guide
Your display will revert to the default channel display as
soon as a Selcall confirmation is received, or if the call is
unsuccessful.
This flashing display shows that you have
received a call from Station No. 4321.
You can respond to the call immediately by pressing your
microphone PTT switch and commencing communications
with the calling station. Pressing the PTT switch
immediately cancels the Selcall Alarm. Once the Selcall
Alarm has been cancelled, the display will revert to the
default channel display.
When a Selcall is being received you should not adjust the
user controls, as this may result in the incoming call being
lost.
Receiving a Selcall
When receiving a Selcall you will hear a series of
continuous loud beeps (which cannot be adjusted with the
VOLUME control knob) - this is the Selcall Alarm. In
addition your display will flash the Selcall ID of the station
that is calling you. For example:-
Selcall Resend
Please note that you can resend the last recorded Selcall
quickly and easily, by pressing the STAR key twice.
31
Section 6.1
To Next Page
Loading...
General