HF-90 Operation & Installation Guide
Telcall
Telcall (ie. Selcall incorporating a telephone call facility)
allows you to make and receive direct calls to/from a normal
DTMF (touch-pad) telephone, without the need for a
telephone operator.
Telcall must be used in conjunction with an approved
Telephone Interconnect Unit or Service.
This display shows that Selcall has been
initiated.
Next, press the numeric keys to select the appropriate Selcall
ID (four digits). This will be the Selcall ID of the
Telephone Interconnect Station. As you press each
individual numeric key, the corresponding number will
appear on the display until all numbers have been selected.
As this point all numbers will appear on the display
together. An example is illustrated on the following page:-
Sending a Telcall
To send a Telcall
use the DTMF
keypad on your
mic./handset
Prior to sending a Telcall, ensure you are on the correct
Selcall/Telcall channel. We recommend using the Beacon
facility to select the appropriate Selcall/Telcall channel
(refer to Section 6.3 in this Guide).
First press the STAR (*) key. Pressing the STAR key will
initiate Selcall - the first step required in sending a Telcall.
Your display will appear as follows:-
33
Section 6.2
To Next Page
Loading...
General