6 7
SYSTEM CONNECTIONS 39
Q-SEE PRODUCT WARRANTY 40
Questions or Comments? Contact Us 41
FOR YOUR SAFETY
To prevent damage to your Q-See product or injury to yourself or to others, read the
following safety precautions in their entirety before installing or using this equipment.
Keep these safety instructions where all those who use the product will read them.
Use the proper power source. Do not use this product with a power source that applies
more than the specied voltage (100-240V AC).
Never insert anything metallic into the DVR. Inserting anything into the DVR or its case
can be a source of dangerous electric shock.
Do not operate in dusty areas. Avoid placing the DVR in places that are dusty.
Do not expose this product to rain or use near water. If this product accidentally gets
wet, unplug it and contact an authorized dealer immediately.
Keep product surfaces clean and dry. To clean the outside case of the DVR, gently wipe
using a lightly dampened cloth (only use water, do not use solvents).
Do not attempt to remove the DVR cover. If there are any unusual sounds or smells
coming from the DVR, unplug it immediately and contact an authorized dealer or
service center. Warning: Do NOT remove the DVR cover as it may result in severe
electrical shock.
Handle DVR box carefully. If you accidentally drop your DVR on any hard surface, it
may cause a malfunction. If the DVR doesn’t work properly due to physical damage,
contact an authorized dealer for repair or exchange.
Use standard lithium cell battery (pre-installed). The standard lithium cell 3v battery,
located on the motherboard, should be replaced if the time clock resets during a power
outage. Warning! Unplug the DVR before replacing the battery or it may result in severe
electrical shock. Properly dispose of old batteries.
Make sure there is proper air circulation around the unit. This DVR system uses a hard
drive for video storage which generates heat during operation. Do not block air holes
located on the bottom, top, sides and back of the DVR as they are designed to keep the
system cool while running. Install or place this product in an area where there is ample
air circulation.
Provide proper ventilation. This DVR has a built-in fan that properly ventilates the
system. Do not cover or impede this fan.
To Next Page
Loading...
Need help?
General
