15
SLIDE ‘N CLICK MINI ANCHORAGE INSTALLATION Q5758001
Determine location of Anchorages, refer to Figure 1 to 2
1. Drill 7/32” (13.5mm) hole through the vehicle oor. Place the Bolt through the OMNI Slide ‘N Click Mini Floor
Anchorage and oor.
2. From underneath vehicle oor, put Bolt through Backing Plate and Washer (F).
We recommend using sealant between Backing Plate and oor
3. Secure Bolt with Locknut, leaving a minimum of 2-3 threads from Bolt sticking out
Recommended torque, 35 FT/LB (47 Nm).
This anchorage has a raised prole and may cause a trip hazard, consideration should be given to
its suitability if used in a vehicle aisle, vehicle entrance or pathways.
OMNI® Slide ‘N Click Mini® Floor Anchorage
Backing Plate
Floor
Recommended Torque,
35 FT/LB (47 Nm)
Bolt
Washer
Locknut
F
To Next Page
Loading...
