Q'STRAINT QRT-1 Series - Page 23

23
INSTALLING SHOULDER BELT UPPER
ANCHORAGE – TRIANGULAR BRACKET
18. Determine location of shoulder belt anchorage in
wheelchair location – see section MANUAL SHOULDER
BELTS.
This bracket is ONLY for Manual belts, not
retractable Shoulder belts.
19. Verify triangular bracket is on solid frame member of
vehicles wall
NOTE: A series of in-line rivets or screws usually indicate
the locations of a frame members in the wall structure
20. Place triangular bracket on mounting location
ensuring the triangular ‘point’ is facing in towards the
wheelchair location. Use bracket as a template to
mark holes to be drilled
21. Drive ve pilot/start holes into the solid frame
member of the vehicle wall structure. Install the
triangular bracket using the supplied ¼” (6.5mm)
hardware (DD)
22. Make sure the shoulder belt is secure but has ability
to swivel and snap plastic cover into place.
LAPBELT ANCHORAGES
LAPBELT CONNECTS TO REAR TIEDOWNS
23. The wheelchair needs to be positioned within the
wheelchair space to give the lapbelt angles within the
recommended zones (EE)
SHOULDER AND LAP BELT INSTALLATION
EE
Preferred Zone
DD