Q'STRAINT QRT-1 Series - Page 27

27
SHOULDER AND LAP BELT INSTALLATION
8
Floor
8
Wall
8
Locknut
8
Bolt
8
2-3 Threads
OO
38. Put Bolt through Retractor, L-Bracket and
Washer—tighten with Locknut (NN).
Recommended torque = 35 FT/LB (47Nm)
39. Place Bolt through vehicle oor. From underneath
vehicle, place Bolt through Backing Plate, Washer
and Locknut (OO).
For proper webbing movement, mounted
retractor MUST be at 0º (zero degree)
rotation with respect to vertical access.
We recommend using a sealant between L-Bracket
and oor—oor and Backing Plate Secure Bolt with
Locknut, leaving a minimum of 2-3 threads from
Bolt sticking out (OO).
Recommended torque = 35 FT/LB (47Nm)
NN
8
Shoulder Belt Retractor
8
Washer
8
Bolt
8
L-Bracket
8
Locknut