Intorduction
1 -
2
• Supports memory ECC (Error Checking and Correction) function.
On-board IDE
• Supports two PCI PIO and bus Master IDE ports.
• supports up to Mode 4 Timing
• Supports 2 Fast IDE interfaces for up to 4 IDE devices including IDE
hard disks and CD ROMs
• Supports “Ultra DMA/33” Synchronous DMA mode transfers up to
33 Mbytes/sec.
• Integrated 8x32bit buffer for IDE PCI Burst Transfers.
Green function
• Supports Advanced Configuration and Power Interface (ACPI)
specification and OS Directed Power Management.
• Supports three green modes: Doze, Standby and Suspend.
• Power LED will blink when the system is in green status.
On-board I/O
• Use NS Plug & play I/O chip PC87309
• One floppy port supports up to two 3.5”or 5.25” floppy drives
360K/720K/1.2M/1.44M/2.88M format.
• Supports LS-120 floppy disk drive
• All I/O port can be enabled/disabled by BIOS setup
• Two high speed 16550 fast compatible UART (COM1/COM2/COM3
/COM4 selectable) with 16-byte send/receive FIFOs and support
MIDI mode.
• One enabled parallel port at I/O address 378H/278H/3BCH with
additional bi-direction I/O capability and multi-mode
(SPP/EPP/ECP) (IEEE1284 compliant).
• Provides protection circuit to prevent damage to the parallel port
when a connected printer is powered up or operated at a higher
voltage.
To Next Page
Loading...
Need help?
General
