A – Command Line Interface
CIMListener Command
59097-02 B A-13
A
CIMListener Command
Configures CIM indication service listeners and adds subscriptions to listeners.
Refer to the ”CIMSubscription Command” on page A-15 for information about
configuring subscriptions.
Authority Admin session and a CIM Edit session. Refer to the ”CIM Command” on
page A-11 for information about opening a CIM edit session.
Syntax cimlistener
add [listener_name] [subscription_list]
create [listener_name]
delete [listener_name]
edit [listener_name]
Keywords add [listener_name] [subscription_list]
Adds the set of subscriptions given by [subscription_list] to the listener given by
[listener_name]. Use a <space> to delimit subscription names in
[subscription_list].
create [listener_name]
Prompts you in a line-by-line fashion to create a CIM listener with the name given
by [listener_name]. [listener_name] can have up to 32 characters: 0-9, A-Z, a-z, _,
$, ^, and -. The CIM listener configuration parameters are described in Table A-3.
delete [listener_name]
Deletes the listener given by [listener_name] from the CIM database.
Table A-3. CIM Listener Configuration Parameters
Parameter Description
Name Listener name
Type Listener type:
Permanent – S
end indications to the CIM client whether a
connection can be established or not. This is the default.
Transient – Sends indications to the CIM client, but ceases
if a connection cannot be established after 60 minutes.
URL IP address of the CIM client and the port number to which to send
indications. The default is 10.0.0.1:5000.
To Next Page
Loading...
Need help?
General
