A – Command Line Interface
Reset Command
59097-02 B A-51
A
Enter the Show Setup SNMP command to display SNMP configuration
values.
Table A-12. Zoning Configuration Defaults
Parameter Default
InteropAutoSave True
DefaultVisibility All
DiscardInactive False
Table A-13. SNMP Configuration Defaults
Parameter Default
SNMPEnabled True
Contact <syscontact undefined>
Location <sysLocation undefined>
Description SANbox 5600 Series FC Switch
Trap [1-5] Address Trap 1: 10.0.0.254; Traps 2–5: 0.0.0.0
Trap [1-5] Port 162
Trap [1-5] Severity Warning
Trap [1-5] Version 2
Trap [1-5] Enabled False
ObjectID 1.3.6.14.1.1663.1.1.1.1.23 (SANbox 5600)
1.3.6.1.4.1.1663.1.1.1.1.24 (SANbox 5602)
AuthFailureTrap False
ProxyEnabled True
To Next Page
Loading...
