A – Command Line Interface
Config Command
59097-02 B A-19
A
The following is an example of how to create a backup file (configdata) and
download the file to the workstation.
SANbox xxxx #> admin start
SANbox xxxx (admin) #> config backup
SANbox xxxx (admin) #> admin end
SANbox xxxx #> exit
#>ftp symbolic_name or ip_address
user: images
password: images
ftp> bin
ftp> get configdata
ftp> quit
The following is an example of how to upload a configuration backup file
(configdata) from the workstation to the switch, and then restore the configuration.
#> ftp symbolic_name or ip_address
user: images
password: images
ftp> bin
ftp> put configdata
ftp> quit
SANbox xxxx #> admin start
SANbox xxxx (admin) #> config restore
The switch will be reset after restoring the configuration.
Please confirm (y/n): [n] y
Alarm Msg: [day month date time year][A1005.0021][SM][Configuration is being
restored - this could take several minutes !]
Alarm Msg: [day month date time year][A1000.000A][SM][The switch will be reset in
3 seconds due to a config restore]
SANbox xxxx (admin) #>
Alarm Msg: [day month date time year][A1000.0005][SM][The switch is being reset]
Good bye.
To Next Page
Loading...
Need help?
General
