A – Command Line Interface
Set Log Command
59097-02 B A-79
A
save
Saves the log settings for the component, severity level, port, and display level.
These settings remain in effect after a switch reset. The log settings can be
viewed using the Show Log Settings command. To export log entries to a file, use
the Set Log Archive command.
start
Starts the logging of events based on the Port, Component, and Level keywords
assigned to the current configuration. The logging continues until you enter the
Set Log Stop command.
stop
Stops logging of events.
Notes In addition to critical, warn, and informative severity levels, the highest event
severity level is alarm. The alarm level describes events that are disruptive to the
administration or operation of a fabric and require administrator intervention.
Alarms are always logged and always displayed on the screen.
To Next Page
Loading...
Need help?
General
