A – Command Line Interface
Set Setup Command
59097-02 B A-91
A
The following is an example of the Set Setup System command:
SANbox xxxx (admin) #> set setup system
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Eth0NetworkDiscovery (1=Static, 2=Bootp, 3=Dhcp, 4=Rarp) [Static ]
Eth0NetworkAddress (dot-notated IP Address) [10.0.0.1 ]
Eth0NetworkMask (dot-notated IP Address) [255.255.255.0]
Eth0GatewayAddress (dot-notated IP Address) [10.0.0.254 ]
AdminTimeout (dec value 0-1440 minutes, 0=never) [30 ]
InactivityTimeout (dec value 0-1440 minutes, 0=never) [0 ]
LocalLogEnabled (True / False) [True ]
RemoteLogEnabled (True / False) [False ]
RemoteLogHostAddress (dot-notated IP Address) [10.0.0.254 ]
NTPClientEnabled (True / False) [False ]
NTPServerAddress (dot-notated IP Address) [10.0.0.254 ]
EmbeddedGUIEnabled (True / False) [True ]
To Next Page
Loading...
Need help?
General
