A – Command Line Interface
Show Command
A-94 59097-02 B
S
fdmi [port_wwn]
Displays detailed information about the device host bus adapter given by
[port_wwn]. If you omit [port_wwn], the command displays a summary of host bus
adapter information for all attached devices in the fabric. Illegal characters in the
display appear as question marks (?).
interface
Displays the status of the active network interfaces.
log [option]
Displays log entries. Refer to the ”Show Log Command” on page A-111. The log is
cleared when the switch is reset or power cycled.
lsdb
Displays Link State database information
mem [count]
Displays information about memory activity for the number of seconds given by
[count]. If you omit [count], the value 1 is used. Displayed memory values are in
1K block units.
ns [option]
Displays name server information for the specified [option]. If you omit [option],
name server information for the local domain ID is displayed. [option] can have the
following values:
all
Displays name server information for all switches and ports.
[domain_id]
Displays name server information for the switch given by [domain_id].
[domain_id] is a switch domain ID.
[port_id]
Displays name server information for the port given by [port_id]. [port_id] is a
port Fibre Channel address.
NOTE: This keyword will display memory activity updates until [count] is
reached – it cannot be interrupted. Therefore, avoid using large
values for [count].
To Next Page
Loading...
Need help?
General
