A – Command Line Interface
Zoneset Command
A-136 59097-02 B
S
deactivate
Deactivates the active zone set. Close the Zoning Edit session before using this
keyword.
del
ete [zone_set]
Deletes the zone set given by [zone_set]. If the specified zone set is active, the
command is suspended until the zone set is deactivated.
list
Displays a list of all zone sets. This keyword does not require an Admin session.
remove [zone_set] [zone_list]
Removes a list of zones given by [zone_list] from the zone set given by
[zone_set]. Use a <space> to delimit zone names in [zone_list]. If [zone_set] is the
active zone set, the zone will not be removed until the zone set has been
deactivated.
rename [zone_set_old] [zone_set_new]
Renames the zone set given by [zone_set_old] to the name given by
[zone_set_new]. You can rename the active zone set.
zones [zone_set]
Displays all zones that are components of the zone set given by [zone_set]. This
keyword does not require an Admin session.
Notes A zone set must be active for its definitions to be applied to the fabric.
Only one zone set can be active at one time.
A zone can be a component of more than one zone set.
Examples The following is an example of the Zoneset Active command:
SANbox xxxx #> zoneset active
ActiveZoneSet Bets
LastActivatedBy admin@OB-session6
LastActivatedOn day month date time year
The following is an example of the Zoneset List command:
SANbox xxxx #> zoneset list
Current List of ZoneSets
------------------------
alpha
beta
To Next Page
Loading...
Need help?
General
