QNAP TS-433-4G User Manual

1. Place your NAS device in an environment that meets the requirements.
For details, see Installation Requirements.
2. Install the drives.
For details, see the following topics:
• Installing 2.5-inch Hard Drives or Solid-State Drives on 3.5-inch Trays
• Installing 3.5-inch Hard Drives on 3.5-inch Trays
3. Connect the power cord and all applicable cables.
4. Power on the NAS.
5. Install QTS.
For details, see QTS Installation.
6. Log on to QTS.
TS-433 User Guide
Product Overview 10

QNAP TS-433-4G Specifications

General

Memory	4 GB DDR4 (non-expandable)
Drive Bays	4
Flash Memory	4GB eMMC
Hot-swappable	Yes
M.2 SSD Slot	No
Form Factor	Tower
Drive Compatibility	3.5" SATA HDD, 2.5" SATA HDD/SSD
HDMI Output	No
Maximum Internal Raw Capacity	80 TB (20 TB drive x 4)
Operating System	QTS
Fan	1 x 120mm
USB Ports	2 x USB 3.2 Gen 1