QNAP TS-AI642 - Page 15

b. Remove the screws on the rear panel.
Note
• The pan head M3x5 screws require a Phillips #1 screwdriver.
• A torque of 2.75 kgf.cm (2.39 lbf.in) ± 0.25 kgf.cm (0.22 lbf.in) is recommended for
electric screwdrivers.
c. Slide the cover back.
d. Lift the cover until it is completely detached from the chassis.
| NAS Repair Manual
Category A NAS Models 14