QNAP TS-AI642 - Page 24

a. Remove the screws that secure the HDMI ports on the system board to the rear panel of
the tray.
Note
• The at head M2x4 screws require a Phillips #1 screwdriver.
• A torque of 2 kgf.cm (1.74 lbf.in) ± 0.5 kgf.cm (0.43 lbf.in) is recommended for
electric screwdrivers.
b. Remove the screws that secure the system board to the tray.
| NAS Repair Manual
Category A NAS Models 23