LED Status Description
System Status Flashes green and red
alternately every 0.5
seconds
• The drive is being formatted.
• The device is being initialized.
• The operating system is being updated.
• RAID rebuilding is in progress.
• Online RAID Capacity Expansion is in progress.
• Online RAID Level Migration is in progress.
• The rmware is being updated.
Important
When updating the rmware, do not remove
the power cord or USB cable, and do not
force-exit the application.
Red • The drive is invalid.
• The shared folder has reached its full capacity.
• The shared folder is about to reach its full capacity.
• The system fan is not functioning.
• An error occurred when accessing (read/write) the
data.
• A bad sector is detected on the hard drive.
• The device is in degraded read-only mode (two
member drives failed in RAID 5 or RAID 6 but the data
can still be read).
• A hardware self-test error occurred.
Flashes red every 0.5
seconds
The device is in degraded mode (one member drive failed
in RAID 1, RAID 5, or RAID 6).
Flashes red once The device has received a command from the remote
control.
Green The device is ready.
Flashes green every 0.5
seconds
• The device is not congured.
• A drive is not formatted.
Flashes orange The device is in sleep mode.
O • All drives are in standby mode.
• The device is powered o.
Drive Status Green The drive is ready.
Red A drive read/write error occurred.
Flashes red 5 times per
second
The drive is being located in the operating system.
O No drive was detected.
TS-hx83XU-RP User Guide
Basic Operations 44
To Next Page
Loading...
Need help?
General
