Setting Up the NAS
Important
Read all safety requirements and information carefully before setting up the NAS or
installing NAS components.
1. Place your NAS device in an environment that meets the requirements.
For details, see Installation Requirements.
2. Optional: Replace or install additional memory modules.
For details, see Replacing Memory Modules.
3. Optional: Install expansion cards.
For details, see Installing Expansion Cards.
4. Optional: Connect expansion units.
For details, see Expansion Unit Installation.
5. Install drives.
For details, see the following topics:
• Installing 3.5-inch Drives on 3.5-inch Trays
• Installing 2.5-inch Solid-State Drives on 3.5-inch Trays
• Installing 2.5-inch Solid-State Drives on 2.5-inch Trays
6. Connect the power cords and all applicable cables.
Note
To set up redundant power supply, connect power cords to both power supply units.
7. Power on the NAS.
8. Install QuTS hero.
For details, see QuTS hero Installation.
9. Log on to QuTS hero.
TS-h3087XU-RP User Guide
Product Overview 12
To Next Page
Loading...
