—26—
Calibration
To make the whiteboard work normally, you must make sure the pen track in the
projector accords with the actual pen track accurately. And calibration of pen function
will get good writing accuracy. You need calibrate your Whiteboard for the below
conditions:
The first time to use the Whiteboard
After reinstall application software and driver
When change the position of the Whiteboard
When change the computer connected with the Whiteboard
After change the resolution and frame rate of the computer
The whiteboard adopts the method of 9 points locate. The steps are as follows:
Step 1: Connect all the equipments and run the whiteboard driver program.
Step 2: Adjust the projector position to make the video project on the Whiteboard and
make sure the projected area is within the range that can be displayed on the
Whiteboard.
Step 3: Click the icon of the Whiteboard driver program at the lower right corner of the
screen, a menu as followed will appear:
Click “Calibrate” to enter calibration screen, shown as below:
To Next Page
Loading...
Need help?
General
