QSC LA108 - Attaching an Array Frame and Stack Adapter Kit to a Subwoofer

24
Attaching an Array Frame and Stack Adapter Kit to a Subwoofer
1. Adhere the adhesive sides of the Bumper Pads to the bottom of the
Array Frame as shown.
2. Place Array Frame on subwoofer with the Bumper Pads facing
downward.
3. Secure the Tie-Down Assembly to the M20 thread located on top, or
side, of the subwoofer enclosure. Tighten screw with fingers until snug.
If necessary, tighten further using a coin, a key, or a large screwdriver.
4. Use the Tie-Down Knob to secure the Array Frame to the Tie-Down
Assembly. Tighten the knob with your hand until snug. Array Frame is
now secured to the subwoofer.
Tie Down Assembly Tie Down Kno
b
Upright
Side
—Figure28—
Array F
rame
Rigging Pin
Bumper Pads
—Figure27—