Installation Manual
4. Power on and Run Router 40
www.qtech.ru
Figure 4-9 “Test properties” interface
Display the following test-HyperTerminal interface, press Enter at the blank
place, and the serial port displays the print information. The setting of the
HyperTerminal is complete.
Figure 4-10 test-Hyperterminal interface after setting
3.4.1. Power on and Start
Check before Power on
Check the router before powering on:
The interface cables, power cables, and PEs are connected correctly.
Power supply voltage meets the power requirement of the device. For details, refer to
Appendix C2 Requirements for Power Supply.
To Next Page
Loading...
