Fitting Handset Batteries
Open the battery cover. Place two AAA batteries in the battery compartment with the polarity as shown. Replace the cover.
Always use AAA batteries and always replace them in sets. Never mix old and new batteries. Very weak batteries can leak and
damage the handset. Replace them in good time.
There is a risk of fire and burns if a battery is handled improperly. Do not disassemble, crush, puncture, short external contacts, or
dispose of in fire or water. Do not attempt to open or service a battery. Discard used batteries in full accordance with recycling
regulations in force in your area.
Handset Operation
Point the handset at the remote receiver and press the relevant key. The handset should be within 15 metres of the player and
there must be a clear line of sight between the two units.
Selecting tracks with the number keypad:
If there are less than 10 tracks: pressing any number will begin playback from the track selected.
If there are 10 - 19 tracks: If you press any key other than “1” the player will jump to the track.
If “1” is pressed the player will pause briefly to allow you to enter another digit. If no key is pressed within the three seconds, track
1 will play.
If there are between 20 & 29 tracks: If you press any key other than “1” or “2” the player will jump directly to the track. If you press
“1” or “2” the player will pause briefly to allow you to enter another digit before starting playback, and so on.
5
1: Open the battery compartment cover
2: Insert 2 AAA batteries
3: Replace the cover
IMPORTANT
SAFETY INFORMATION
REMOTE
HANDSET
CONTROLS AND
FUNCTIONS
CONNECTIONS
SYSTEM
OPERATIONS
DTS PLAY-FI
®
WIRELESS...
MENU
OPTIONS
SPECIFICATIONS CONTENTSINTRODUCTION
WARRANTY
COVERAGE
To Next Page
Loading...
