19
1
Connecting the Power
Connecting the power supply starts the software steps for the machine setup.
Remove the power supply and power cable from the packaging.
The machine starts and launches the installation wizard automatically.
Only use the Power Supply Cord delivered with the Mailing Sys-
tem.
• Plug the female connector of the
power supply cord into the bottom
back connector of your system.
• Plug the male end of the power
supply cord into a wall socket.
ALPHA1_IR.book Page 19 Vendredi, 16. décembre 2011 11:49 11
To Next Page
Loading...
Need help?
General
