EasyManuals Logo

Quantum DXi6701 User Manual

Quantum DXi6701
48 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #29 background imageLoading...
Page #29 background image
Initial Configuration 27
DXi6701/DXi6702
Figure 17 Internet Protocol
(TCP/IP) Properties Window
d Select Use the following IP Address and then enter the following information:
Caution: Before changing the IP address information, write down the
original settings. This will be used later to reset the network
configuration.
IP address - 10.1.1.2
Subnet mask - 255.255.0.0
e Click OK.
f Wait at least two minutes for the computer to set the IP addresses on the local
computer.
4 On the computer, open a supported Web browser, type 10.1.1.1 in the Address
box, and press <Enter>.
The Login window displays (see Figure 18).
Note: For Web browsers, DXi6701 and DXi6702 support Firefox 10 or higher,
Chrome 21 or higher, or Internet Explorer 8 or higher (use compatibility
mode for Internet Explorer 10).
Note: If the Login window does not display, verify that you entered the correct IP
address (10.1.1.1) and that the network settings on the computer are
correct. Wait ten minutes, then try again. If the Login window still does not
display, contact Quantum Customer Support. (Contact information is
located on the last page of this document.)
Continue with the next section to log on to the system and complete the Getting
Started wizard.

Other manuals for Quantum DXi6701

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Quantum DXi6701 and is the answer not in the manual?

Quantum DXi6701 Specifications

General IconGeneral
BrandQuantum
ModelDXi6701
CategoryStorage
LanguageEnglish

Related product manuals