Quasimidi POLYMORPH - MIDI Output Filter

To Next Page

To Previous Page

Edit System/MIDI

<8> RXSetChg: OFF

Receiving a Setup program change. When this parameter is "ON", the setups can be selected over

MIDI. The setup changes are received on the MIDI channel that is 4 channels above the master

channel. In the factory setting the master channel is on 1, the setups let themselves be switched

accordingly on MIDI channel 5.

Edit system/MIDI

<9> RxPrgChg: ON

Receiving single program changes. When this parameter is "ON", the single sounds can be switched

over MIDI.

Edit System/MIDI

<10> RxParam: ON

Receiving sound parameters. The POLYMORPH sends all control changes using a conventional

MIDI controller number. To also receive these messages, RxParam: must be ,,ON".

MIDI output filter

On menu pages 11-14 you can choose what MIDI data from the POLYMORPH will be sent out.

Edit System/MIDI

<11> TXClock: ON

You decide in this menu, if the POLYMORPH clock information is sent or not. Only when it is sent

can the other instruments like the RAVE-O-LUTION 309 run in synchronized Tempo with the

POLYMORPH.

Edit System/MIDI

<12> TxSetCh: OFF

Here you decide if the POLYMORPH sends the program change messages of its setup changes

over MIDI. In the position "ON" it sends every change of a setup as a corresponding program

change.

Edit System/MIDI

<13> TxPrgCh: ON

Here you select whether the POLYMORPH single program changes are sent by MIDI or not, when

<SOUND> is turned, and it is in the single sound mode.

Edit System/MIDI

<14> TxParam: ON

Here you can decide if the MIDI controller data of the control knobs will be sent over MIDI or not.

The System Menu