Quasimidi POLYMORPH - Initializing a Setup; Initializing a Sound; Initializing the Effect Section of a Sound;Fx-Bypass Function

Initializing a setup
When initializing a setup the momentary settings of all four parts and sequences are set to a neutral
output condition. When you want to program a setup from the basics, then you should use this
function.
1.) Push [WRITE] to get in the write menu.
2.) Select menu page 4 of the write menu by using [PAGE<>]. The display shows:
<4> Init Setup?
[ok]
3.) With [F1] you can initialize the setup.
4.) Leave the write menu with [EXIT].
Initializing a sound
You can even initialize a single sound. To become acquainted with the synthesizer functions it
helps to start with a basic sound that is transparent.
1.) Push [WRITE] to get in the write menu.
2.) By using [PAGE<>] select page 5. The display shows:
<5> Init Sound?
[ok]
3.) With [F1] you can initialize the sound.
4.) Leave the write menu with [EXIT].
Initializing the effect section of a sound/FX-Bypass function
With this function the Effect section of a sound can be initialized or be loaded with preset standard
values. These preset settings are also printed on the surface of the POLYMORPH. Let's see how to
do it:
1.) Push [WRITE] to get in the write menu.
2.) By using [PAGE<>] select page 6. The display shows:
<6> Init Effect?
[ok]
3.) Confirm with [F1]. The display shows:
Multi: SpaceDist1
[ok] [cancel]
4.) Select with <VALUE> the desired effect setting. Since the adjustment is for all four single
effects (distortion, EQ, FX-1 and FX-2), appears in the display "Multi". Eight different
settings are available:
51
The write menu