Quasimidi POLYMORPH - Send Temp - Sending the Momentary Settings; Send Sounds - Sending the User Sound Memory; Send Sequences - Sending the Sequencer Memory

If problem occur with the data transfer, look in the section "Sysex Dump speed" in the chapter
System menu. There you can select three different speeds.
Send Temp - Sending the momentary settings
On menu page 8 the actual settings of all four parts and sequences can be sent to an external piece
of equipment. In connection with a software sequencer the dumping function works well, because
at the beginning of a song you can send the complete active settings to the POLYMORPH. Do the
following to send the momentary condition of the POLYMORPH over MIDI:
1.) Push [WRITE] to get in the write menu.
2.) By using [PAGE<>] select page 8. The display shows:
<8> Send Temp?
[ok]
3.) Start the recording of the external sequencer, dump utilities etc.
4.) Push [F1] to start the data transfer.
5.) Leave the write menu with [EXIT].
Send sounds - Sending the user sound memory
In this menu you can archive the 128 single sounds of the POLYMORPH.
1.) Push [WRITE] to get into the write menu.
2.) By using [PAGE<>] select page 9. The display shows:
<9> Send sounds?
[ok]
3.) Start the recording of the external sequencer, dump utilities etc.
4.) Push [F1] to start the data transfer.
5.) Leave the write menu with [EXIT].
Send sequences - Sending the sequencer memory
In addition to the setups the POLYMORPH has a memory for 50 sequences. They are sent as
follows:
1.) Push [WRITE] to get into the write menu.
2.) By using [PAGE<>] select page 10. The display shows:
<10> Send Seq.'s?
[ok]
3.) Start the recording of the external sequencer, dump utilities etc.
4.) Push [F1] to start the data transfer.
5.) Leave the write menu with [EXIT].
53
The write menu
See page 47