EasyManua.ls Logo

Quasimidi POLYMORPH - Page 61

Quasimidi POLYMORPH
69 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
56 fx2 typ 0..5 (FLANGER...PANDELAY)
57 fx2 level 0..127
58 fx2 feedback 0..127
59 fx2 delay time 0..126,127 (time depents on typ, synced)
5A fx2 mod. rate 0..127
5B fx2 mod. depth 0..127
5C eq1 gain 0..127
5D eq1 frequency 0..127
5E eq2 gain 0..127
5F eq2 frequency 0..127
60 distortion gain 0,1..127 (OFF,1..127)
61 distortion cutoff freq. 0..127
62 distortion resonance 0..127
63 fx2 feedback filter 0..127
Sequence Parameter
Adr. Parameter Value (Remarks)
00 sequence direction bit 0..1: forward,backward,random
bit 2: notes forward
01 line 1 assign FF,0..97 (not assigned, Ctrl.No.)
02 line 2 assign FF,0..97 (not assigned, Ctrl.No.)
03 line 3 assign FF,0..97 (not assigned, Ctrl.No.)
04 pitch line last step 0..15
05 ctrl line 1 last step 0..15
06 ctrl line 2 last step 0..15
07 ctrl line 3 last step 0..15
08..17 pitch steps 0..48
18..27 line 1 steps 0..127 (-64..+63)
28..37 line 1 steps 0..127 (-64..+63)
38..47 line 1 steps 0..127 (-64..+63)
(only stored in Setup memory section...)
48 transpose 40..88 (-24..+24)
49 sequence control bit 0..2: resolution (1..1/32)
bit 5: realtime transpose on/off
bit 6: sequence on/off
4A start trigger source 0,1..4,5..20 (FREE,SEQ1..4,EXT1..16)
4B start trig. step/note 0..15
4C..53 sequence variations bit 0..6: transpose
bit 7: sequence on/off
Identity Request
Byte Value Remarks
00 F0 System Exclusive start command
01 7E Common Non-Real-Time message
02 cc channel number = system channel-1 *
03 06 general information
04 01 identity request
05 F7 end of System Exclusive
Identity Reply
Byte Value Remarks
00 F0 System Exclusive start command
01 7E Common Non-Real-Time message
02 cc channel number = sytem channel-1 *
03 06 general information
04 02 identity reply
05 3F QUASIMIDI id
06 26 POLYMORPH id
07 xx reserved
08 xx reserved (Expension Board 1 exists (00=no, 01=yes))
09 xx reserved (Expension Board 2 exists (00=no, 01=yes))
10..13 v v v v Version no. (4 ascii characters, i.e '1.00')
14 F7 end of System Exclusive
* note that if cc = 7F the POLYMORPH respond regardless
of what master channel it is on
61
POLYMORPH System-Exclusive Format

Table of Contents