Queclink GV55 - Digital Inputs

GV55NUsermanual 
TRACGV55NUM001 ‐15‐
IGN signal can be configured to start transmitting information to backend server when
ignition is on; and enter power saving mode when ignition is off.
There are one general purpose digital inputs on GV55N. They are all negative trigger.
Table 7. Electrical Characteristics of the digital inputs
Logical State Electrical Characteristics
Active 0V to 0.8V
Inactive Open
The following diagram shows the recommended connection of a digital input.
Figure 10. Typical Digital Input Connection
There are two digital outputs on GV55N. All are of open drain type and the maximum drain
current is 150mA. Each output has the built-in over current and recovery PTC fuse
3.8. DigitalInputs
3.9. DigitalOutputs