Quectel BG95 Series - AT+QPING Ping a Remote Host

LPWA Module Series
BG95&BG77&BG600L Series TCP/IP Application Note
BG95&BG77&BG600L_Series_TCP/IP_Application_Note 27 / 56
Parameter
2.3.11. AT+QPING Ping a Remote Host
This command tests the reachability of a host on an Internet protocol network. Before using the ping utility,
the host should activate the context of corresponding <contextID> with AT+QIACT first. The command
returns the result within <timeout>.
AT+QISWTMD Switch Data Access Mode
Test Command
AT+QISWTMD=?
Response
+QISWTMD: (range of supported <connectID>s),(range of
supported <access_mode>s)
OK
Write Command
AT+QISWTMD=<connectID>,<access
_mode>
Response
If <access_mode> is 0 or 1, and data access mode is
switched successfully:
OK
If <access_mode> is 2 and data access mode is switched
successfully, the module enters data mode (i.e. transparent
transmission mode):
CONNECT
If there is any error:
ERROR
Maximum Response Time
300 ms
Characteristics
/
<connectID>
Integer type. Socket service index. Range: 0–11.
<access_mode>
Integer type. Data access modes of the connection.
0 Buffer access mode
1 Direct push mode
2 Transparent transmission mode
AT+QPING Ping a Remote Host
Test Command
AT+QPING=?
Response
+QPING: (range of supported <contextID>s),<host>,(range
of supported <timeout>s),(range of supported <pingnum>s)