Chapter 3 Detailed Operating Instructions
14
Refer to the following instrument diagram when operating the aq-5001 IAQ Monitor:
THUMBSCREW THREADS
THUMBSCREW
WAND COVER
HOLE PLUG
To mount the wand on the aq-5001 for use as a portable IAQ Monitor:
1. Remove the rubber hole plug from the side of the case (the
cord will retain it)
2. Lay the case flat and open the cover.
3. Lift the aq-5000 from its nesting location and slide it out of the
way (disconnect cables if necessary). Feed the wand through
the hole, stopping at the coil.
To Next Page
Loading...